Entone VUDU Installationshandbuch PDF herunterladen (Seite 13)

1. Initial Startup

When you connect power to your set-top box for the first time, you’ll configure

the set-top box and log in to fs|cdn.

IMPORTANT: Do not disconnect power to the set-top box until Startup is complete.

This will take up to 10 minutes. During this time the set-top box will shut down

and start up again, lights may flash or blink, and messages will appear on your TV

screen.

Startup is complete when the Welcome screen on your TV screen prompts you for

your password (see “Log in” on page 2).

Follow the instructions below to set up your system.

Program the remote control

Before you can use the remote control, you’ll need to program it for your TV

brand. Follow the instructions included with your remote control.

Validate the set-top box

Install the set-top box according to the installation manual.

Connect the AC power and wait a moment for the screen to activate.

The Welcome screen will display.

Screen background may vary.

On the remote control, press the STB button.

Use the number keys on the remote control to enter the 8-digit PUK (pin

unlock code) available from your fs|cdn provider.

Press OK.

If you make a mistake typing the PUK, press

Pg Back (



) to erase the error.

Continue with “Log in.”

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 56 57

Keine Kommentare

Entone VUDU Installationshandbuch Seite 13